How To Calibrate The Terminal Fm When Using The Operation Panel (Fr-Du07) - Mitsubishi Electric FR-F720P-0.75K to 110K Instruction Manual

Fr-f700p series
Hide thumbs Also See for FR-F720P-0.75K to 110K:
Table of Contents

Advertisement

4.12.5 How to calibrate the terminal FM when using the operation panel (FR-DU07)

Perform the following procedure to calibrate terminal FM using the operation panel FR-DU07. Refer to page 159 for
the details of parameters.
Operation
1.
Confirmation of the RUN indicator and
operation mode indicator
2.
Press
to choose the parameter
setting mode.
3.
4.
Press
to read the present set value.
"
" (initial value) appears.
5.
Turn
to change it
to the setting value of "
6.
Press
to set.
7.
Turn
until
8.
Press
to display
9.
Turn
until
Set to C0 FM terminal calibration.
10.
Press
to enable setting.
11.
If the inverter is at a stop, (press
or
) to start the inverter.
(Motor needs not be connected.)
12.
Turn
to adjust the indicator needle
to the desired position.
13.
Press
. Setting is complete.
REMARKS
⋅ Calibration can also be made for external operation. Set the frequency in External operation mode, and make calibration in
the above procedure.
⋅ Calibration is available even during operation.
⋅ For the operating procedure using the parameter unit (FR-PU04/FR-PU07), refer to the parameter unit instruction manual.
♦ Parameters referred to ♦
C0(Pr.900) FM terminal calibration
C1(Pr.901) AM terminal calibration
".
Flicker...Parameter setting complete!!
appears.
.
appears.
(
) )
+
-
Flicker...Parameter setting complete!!
By turning
, you can read another parameter.
Press
to return to the
Press
twice to show the next parameter (
Refer to page 159
Refer to page 159
Monitor display and monitor output signal
Display
(When Pr. 54=1)
The parameter
number read
previously appears.
C0 to C7
setting
is enabled.
The monitor set to Pr. 54 FM terminal
function selection is displayed.
Analog indicator
indication (step 8).
).
4
161

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents