Panasonic LUMIX DMC-GM1 Operating Instructions For Advanced Features page 170

7. Shutter and Drive Settings
•
When a high ambient temperature, continuous recording in Burst Mode or other conditions are
causing the camera to overheat, [
camera will turn off automatically to protect itself. When this happens, some functions will be
disabled until the camera cools down.
•
When the burst speed is set to [SH] or [H] (when focus mode is [AFS] or [MF]), the exposure
and White Balance are fixed at the settings used for the first picture for the subsequent pictures
as well.
When the burst speed is set to [H] (when focus mode is [AFF] or [AFC]), [M] or [L], they are
adjusted each time you take a picture.
•
Since the shutter speed becomes slower in dark places, the burst speed (pictures/second) may
become slower.
•
Depending on the operating conditions, it may take time to take the next picture if you repeat
the recording of pictures.
•
It may take time to save pictures taken in Burst Mode on the card. If you take pictures
continuously while saving, the maximum number of recordable pictures decreases. For
continuous shooting, use of a high speed memory card is recommended.
Not available in these cases:
•
The Burst Mode is disabled in the following cases.
–
[Glistening Water]/[Glittering Illuminations]/[Handheld Night Shot]/[Soft Image of a Flower]
(Scene Guide Mode)
–
[Rough Monochrome]/[Silky Monochrome]/[Miniature Effect]/[Soft Focus]/[Star Filter]/
[Sunshine] (Creative Control Mode)
–
When White Balance Bracket is set
–
When recording motion pictures
–
When recording using the flash
–
When recording with [iHandheld Night Shot]
–
When [HDR] is set to [ON]
–
[Multi Exp.]
–
When using [Time Lapse Shot]
– In [Stop Motion Animation] (only when [Auto Shooting] is set)
•
In the following cases, [SH] in Burst Mode cannot be used.
–
When [Quality] is set to [
–
When using [Stop Motion Animation]
] flashes. If a message is displayed after [
], [ ] or [ ]
170
] flashes, the