Table of Contents
Advertisement
1.
Before mounting a lens, check whether it is CS-mount lens.
Dimension (b) of the lens shown in the illustration must be as shown
in the table below. If (b) exceeds the value in the table, it may dam-
age the inside of the camera or correct mounting may be impos-
sible; never use such lenses. The F mark indicates a focal point.
CS mount lens
* When using the C-mount lens, use the conversion ring (CM46633-
001, MOUNT ADAPTOR).
2.
Attach the included ferrite core to the lens cable. Please attach it
as close to the camera as possible.
3.
Mount the lens on the camera by turning the lens clockwise. Adjust
its position.
4.
When using an auto-iris lens with an EE amplifier, turn the switch to
the "VIDEO" side. When no EE amplifier is equipped, turn the switch
to the "DC" side.
5.
If the lens has an auto-iris mechanism, connect the lens cable after
checking the pin arrangement.
If the lens cable has a different type of plug, use the 4-pin plug.
[4-pin plug part no: SCV2859-001]
Contact your dealer of purchase concerning the 4-pin plug.
Lens DC IRIS
Pin No.
1
2
3
4
Lens
Flange back (c)
(does not contain EE amplifier) (contain EE amplifier)
Brake
Brake
Drive
Drive
12.5mm
VIDEO IRIS
–
+
+
–
Dimension (b)
5.5mm or less
9V [max 50mA]
NC
VIDEO
GND
15
Advertisement
Table of Contents
