Embedding The Camera To The Ceiling - JVC TK-C215V4U Instructions Manual

Installation and connection
Mounting the Camera
(continued)

Embedding the camera to the ceiling

* Make use of a ceiling material with a thickness
between 9.5 mm to 22 mm.
Setup
1.
Open a hole in the ceiling. (R120 mm, 4 3/4
inches)
2.
Draw the fall prevention wire mounted to
the ceiling slab and the cable out from the
ceiling in advance.
CAUTION:
● Select a suitable fall prevention wire based
on length, strength, location, material
(insulation property), etc.
● Use a ring on the fall prevention wire for
mounting to the camera unit with an
internal diameter of at least R3.1 mm or and
not larger than R5.5 mm, and an external
diameter that is not larger than R 9 mm.
R120 mm
(4 3/4 inches)
1.
Fall prevention
wire
(not supplied)
Video signal cable
3.
Remove the dome cover.
As illustrated in the diagram, hold the dome
ring such that the position mark comes
between the thumb and index finger. Turn the
ring in the counterclockwise direction to
remove.
3.
Dome Ring
14
Approx. 100 mm
(3 7/8 inches)
2.
Power supply cable
Position mark
4.
Remove the inner dome
The inner dome is secured with claws
(3 locations). Hold the inner dome and
remove it from the claws.
5.
Remove the outer case.
(This method does not require an outer case.)
A
Loosen the camera fastening screw with a
screwdriver
B
To remove, turn the camera unit in the
counterclockwise direction
6.
Dismantle the supplied fall prevention wire
Unfasten the mounting screw for the fall
prevention wire at the rear of the camera unit
7.
Loosen the pan fastening screw.
CAUTION:
Moving the lens unit without loosening the pan
fastening screw may damage the lens unit.
8.
Set the switches for video images.
( A pg. 10)
4.
7.
Claws
(3 locations)
5.
B
Inner Dome
5.
Pan fastening
Screw
A
Camera
Fastening Screw
6.
Washer