Adjusting Images - JVC TK-C215V12 Instructions Manual

1.
Attach from
the ceiling
slab
3.
Fall prevention
wire
(not supplied)
TK-C215V4 is used in the above illustration.
4.
Connect the video signal cable. (A pg. 14)
Lower the protection cover and connect the
connectors. Upon connecting, restore the
protection cover to cover the connectors.
5.
Connect the input power supply cable.
(A pg. 16)
6.
Connect the alarm cable.(TK-C215V12 only)
(A pg. 15)
7.
Wrap insulation tape around cables.
4.
Protection
cover
*TK-C215V12 is used in the above illustration
Outer case
mounting screws
Less than 4 mm
2.
Be sure to loosen
the screw.
Alarm signal cable
(TK-C215V12 only)
5.6.
Solder or crimp
Insulation tape
Wrap with tape
7.
Input power
supply cable
Mounting
1.
Align the position mark of the fastened
outer case with that of the camera unit.
NOTE:
When doing so, be careful not to catch the
cables in the outer case.
2.
Turn the camera unit in the clockwise
direction.
T When doing so, ensure that the X mark is
visible. (See illustration below)
3.
Fasten the camera by tightening the camera
fastening screw.
Position
mark
1.
*TK-C215V4 is used in the above illustration.

Adjusting Images

After mounting is completed, adjust the
images while checking the actual image.
(A pg. 23 Adjusting Images )
2.
T Check
Camera
fastening screw
3.
21