Operation - Makita 9067 Instruction Manual

in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
4
004263
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
Super flange
Models 9067F, 9069F, 9067SF and 9069SF are
standard-equipped with a super flange. Only 1/3 of
efforts needed to undo lock nut, compared with
conventional type.
For Australia and New Zealand
004264
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
with its protrusion facing downward (facing toward the
wheel).
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
001089
To remove the wheel, follow the installation procedure in
reverse.
1. Lock nut
1
2. Depressed
center wheel
2
3. Super flange
3
4. Inner flange
1. Lock nut
45
1
2. Depressed
2
center wheel
3. Inner flange
102
3
1. Lock nut wrench
2. Shaft lock
Installing or removing cut-off wheel
45
1
78
2
3
78
4
004351
For Australia and New Zealand
Mount the inner flange onto the spindle. Fit the cut-off
wheel on over the inner flange.
Mount the outer flange on the wheel and screw the lock
nut with its protrusion facing downward (facing toward
the wheel).
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.

OPERATION

WARNING:
It should never be necessary to force the tool. The
•
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while
•
grinding.
NEVER bang or hit grinding disc or wheel onto
•
work.
Avoid bouncing and snagging the wheel, especially
•
when working corners, sharp edges etc. This can
cause loss of control and kickback.
NEVER use tool with wood cutting blades and other
•
sawblades. Such blades when used on a grinder
frequently kick and cause loss of control leading to
personal injury.
CAUTION:
After operation, always switch off the tool and wait
•
until the wheel has come to a complete stop before
putting the tool down.
8
1. Lock nut
2. Outer flange 78
3. Cut-off wheel
4. Inner flange 78
5. Dust collecting
wheel guard
5