Pc Settings Menu - Sony KDL-26S2000E Service Manual

Set-up menu
Auto Start-up
Starts the "first time operation menu" to select the language and country/region, and
tune in all available digital and analogue channels. Usually, you do not need to do
this operation because the language and country/region will have been selected and
channels already tuned when the TV was first installed (page 5, 6). However, this
option allows you to repeat the process (e.g., to retune the TV after moving house,
or to search for new channels that have been launched by broadcasters).
Language
Selects the language in which the menus are displayed.
AV Preset Assigns a name to any equipment connected to the side and rear sockets. The name
will be displayed briefly on the screen when the equipment is selected. You can skip
an input source that is not connected to any equipment.
F f
1 Press / to select the desired input source, then press
F f
2 Press / to select the desired option below, then press
Equipment labels: Uses one of the preset labels to assign a name to connected
equipment.
"Edit": Creates your own label. Follow steps 2 to 4 of "Programme Labels"
(page 29).
"Skip": Skips an input source that is not connected to any equipment when you press
to select the input source.
Auto S Video Selects the input signal from S video sockets
connected.
Timer Settings
Sets the timer to turn on/off the TV.
Sleep Timer
Sets a period of time after which the TV automatically switches itself into standby
mode.
When the Sleep Timer is activated, the
up in orange.
Tips
• If you switch off the TV and switch it on again, "Sleep Timer" is reset to "Off".
• "TV will soon turn off by sleep timer." appears on the screen one minute before the TV
switches to standby mode.
You can select the options listed below on the Set-up
menu. To select options in "Settings", see "Navigating
through menus" (page 20).
.
.
5 when / 5 sockets are both
(Timer) indicator on the TV (front) lights

PC Settings menu

Screen Format Selects a screen mode for displaying input from your PC.
"Normal": Displays the picture in its original size.
"Full1": Enlarges the picture to fill the display area, keeping its original horizontal-
to-vertical aspect ratio.
"Full2": Enlarges the picture to fill the display area.
Reset Resets all the PC settings to the factory settings.
Auto Adjustment
Automatically adjusts the display position and phase of the picture when the TV
receives an input signal from the connected PC.
Tip
Auto Adjustment may not work well with certain input signals. In such cases, manually adjust
"Phase", "Pitch", "Horizontal Shift" and "Vertical Shift".
Phase
Adjusts the phase when the screen flickers.
Pitch Adjusts the pitch when the picture has unwanted vertical stripes.
Horizontal Shift
Adjusts the horizontal position of the picture for each screen format.
Vertical Shift
Adjusts the vertical position of the picture for each screen format.
Power Management Switches the TV to standby mode if no signal is received for 30 seconds.
You can select the options listed below on the PC
Settings menu. To select options in "Settings", see
"Navigating through menus" (page 20).