Output Driven Gear Installation; Ft·lb) - Honda 1984 Shadow VT700C Manual

CRANKSHAFT/TRANSMISSION
OUTPUT DRIVEN GEAR INSTALL AT ION
NOTE :
Remove the center guide from the dis!
assembly tool before using.
When the gear set, driven gear bearing and/
or gear case has been replaced, use a shim
0.30 mm (0.012 in) thick for initial re-
ference.
Place the output driven gear bearing holder into a
press.
Then press in the output driven gear.
Support the inner bear ing race using the special
tools.
Insta ll the O·ring and correct shim.
Attach the bearing holder onto the gear case with
the four hex bolts. Tighten the bolts in a crisscross
pattern in two or more steps.
TORQUE: 30-40 N'm (3.0-4.0 kg-m,
22-29
ft·lb)
Install a new bearing inner race lock nut and tighten
it to the specified torque.
TORQUE : 70-80 N'm (7.0-8.0
kg-m,
51-58
ft-Ib)
Torque wrench scale reading :
64-73 N·m (6.4-7.3 kg·m. 46-53 ft·lb)
13-28
"'-o;;iiASS:~~L ~ Y
TOOL
07965-3710100
BEARING INNER RACE
LOCK NUT
07923-689010 1
L OCK NUT WRENCH, 30/64
mm