Mitsubishi Eclipse Workshop Manual page 331

REAR AXLE
<4WD>
-
Differential
Carrier
27-31
o
O
o
o
o
I
o;
M8990685
M8990326
l
r
F043
(6)
lnstall the drive pinion assembly and companion flange
with mating marks properly aligned, and tighten the
companion flange self-locking
nut
to
the
specified
torque by using the
special tools.
(7)
Measure the drive pinion turning torque (with
oil
seal|
by using the special tools to verify that the drive pinion
turning torque complies with the
standard value.
Sandard
value:
lf
there is a
deviation
from the
standard value, check
whether or not there is incorrect tightening torque of
the companion flange tightening self-lock nut. or
incor-
rect fitting of the oil
seal.
o
ADJUSTMENT OF DIFFERENNAL GEAR BACKLASH
Adjust
the
differential gear backlash
by the
following
procedures:
(1) Assemble
the
side gears, side gear spacers,
pinion
gears, and pinion washers into
the
differential
case.
(2) Temporarily install
the pinion
shaft.
NOTE
Do not drive in the lock pin
yet.
(3) Adjust
the differential gear backlash by the following
a
procedures:
,F
O
Wnite
locking
the
side gear
with the
wedge,
measure
the differential gear backlash with a
dial
indicator on the pinion
gear.
NOTE
The
measurement should
be
made
for
both
pinion
gears
individually.
Sandard
value:
Limit:
0-0.076
mm |O-O.O03 in.l
O.2
mm
(O.OO8 in.)
F'.:.
Bearing
classification
Bearing
lubrication
Rotation torque
(starting
friction torque)
Nm
(kgcm.
in.lbs.)
New
None (with rust-
prevention oil)
1.0- r.3
(10.0-13.0,9-111
New,/reused Oil
application
0.5-
0.6
(5.0-6.0.4-5)
:i..s
'f,i;
:;
FWUE9010