Riso RZ1090 User Manual page 243

T00-000:Service Call Error (in alphabetical order)
Message
!!Battery Replacement!!
Call Service
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
!!System Error!!
Turn Main Power SW OFF Then ON
If Recovery has Failed, Call Service
A00-000:Jam Errors (in alphabetical order)
Message
Master Disposal Error
Pull Out Print Cylinder and
Discard Master
Master Jammed in Disposal Unit
Pull Out Master Disposal Box and
Remove Jammed Master
Master Loading Error
Pull Out Print Cylinder and
Discard Master
Master Mis-Feed
Pull Out Master Making Unit and
Rewind Master Roll, then
Reset Master in Place
Possible Cause
The battery is low or depleted.
A system error has occurred.
Possible Cause
The master was not properly
discarded.
The master is jammed in the
Master Disposal Unit.
The master did not properly
attach to the Print Drum
(Cylinder).
The master is improperly
installed.
Action
Contact your dealer (or authorized service
representative) and have the battery
replaced.
Press the key or the
the error message display.
Press the key.
If the problem persists, contact your dealer
(or authorized service representative).
Shut off power, then restart.
If the problem persists, contact your dealer
(or authorized service representative).
Action
1)
Pull out the Print Drum (Cylinder) and
remove the master from the Print
Drum (Cylinder).
p.231
2)
Return the Print Drum (Cylinder) in place.
3)
Press the key.
Pull out the Master Disposal Box and
remove the jammed master.
If the masters are difficult to remove, pull out
the Print Drum (Cylinder) and then remove.
p.229
p.231
If the error persists, contact your dealer (or
authorized service representative).
1)
Pull out the Print Drum (Cylinder) and
remove the master from the Print
Drum (Cylinder).
p.231
2)
Return the Print Drum (Cylinder) in place.
3)
Press the key.
Pull out the Master Making Unit, rewind
the master and reinstall.
p.224
When a Message Displays
Troubleshooting
key to clear
243