Mounting The Attachment - Makita BUX360 Instruction Manual

When only the lowermost indicator lamp (next to
•
the "E") blinks, or when none of the indicator lamps
light, the battery capacity has run out, so the tool
does not operate. In these cases, charge the
battery or replace the empty battery with a fully
charged one.
When two or more indicator lamps do not light even
•
after charging is complete, the battery has reached
the end of its service life.
When the upper two and lower two indicator lamps
•
light alternately,
malfunctioned.
authorized service center.
NOTE:
The indicated capacity may be lower than the
•
actual level during use or immediately after using
the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying
out any work on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the grip
1
3
2
013202
Securely fit the barrier and grip onto the shaft pipe with
two screws and clamps.
Make sure that the grip/barrier assembly is located
between the spacer and the arrow mark. Do not remove
or shrink the spacer. Once assembled, do not remove the
barrier.
CAUTION:
Never install the grip on the label or joint.
•
the battery may
Contact your local
1. Grip
2. Clamp
3. Barrier
4. Spacer
4
5. Arrow mark
5
NOTE:
In some countries, the barrier and spacer are not
•
provided with the tool. In that case, align the handle
to further side of the line which is indicated by the
arrow marks.

Mounting the attachment

have
Makita
1
1
4
012660
To mount the attachment to a power unit:
1. Make sure that the lock lever is not tightened.
2. Align the pin with the arrow mark.
3. Insert the shaft into the drive shaft of the power
unit until the release button pops up.
4. Tighten the lock lever firmly as shown.
To remove the attachment, loosen the lock lever, press
the lock button and withdraw the shaft.
NOTICE:
Do not tighten the lock lever without the shaft of the
•
attachment inserted. Otherwise the lock lever may
tighten the entrance of the drive shaft too much and
damage it.
Attaching shoulder harness
012761
Put the shoulder harness on your left shoulder by putting
your head and right arm through it. Keep the tool on your
right side.
After putting the shoulder harness, attach it to the tool by
connecting the buckles provided on both the tool hook
and the harness. Be sure that the buckles click and lock
completely in place.
Adjust the strap to the suitable length for your operation.
8
1. Lock lever
4
2. Pin
3
3. Arrow mark
4. Release button
3
2
2