IP SETUP MENU
To enter the IP SETUP MENU, press the MENU button as soon as the ITP-5121D
phone is connected to the power supply or Power over Ethernet LAN port.
When entering the IP setup menu, the LCD displays the following options:
>1.SYSTEM EASY WIZARD
2.SYSTEM INFORMATION
Other items not shown on screen when scrolling down (press down on navigation
disc):
3.NETWORK SETUP
4.LOAD & UPGRADE SETUP
6.FACTORY RESET
7.REBOOT
Once the IP SETUP MENU is displayed, you can move to each menu in the Set Up
by using the navigation buttons.
•
The UP and DOWN directions buttons in the navigation button assembly are
used to move the highlighted bar up or down to the desired option.
•
The LEFT and RIGHT buttons in the navigation button assembly are used to
move the highlighted bar left or right, to the desired option, move to a sub
menu and if a menu is at the last line, that menu option will be executed.
•
The [0]-[9] dial buttons are used to directly choose a menu, or sub menu
options.
•
The [ENTER] button in the navigation button assembly is used when saving
a modification.
•
The [MENU] button in the navigation button assembly is used to to display
the IP Setup Main Menu.
•
The [END] button in the navigation button assembly is used when canceling
or editing the modification, or existing programming.
•
The [CANCEL] button in the navigation button assembly is used to go back
to the previous screen or to delete the last digit of a displayed option value.
10
5.SYSTEM SERVER SETUP
6.FACTORY RESET
Home Page
MENU STRUCTURE
The IP SETUP MENU is configured as follows:
1. SYSTEM EASY WIZARD
This option will guide you through setting up all required parameters for con-
necting the ITP keyset to your system.
2. SYSTEM INFORMATION
1.
Version Info: Provides boot rom, software, DSP, and hardware version
information.
2.
Network Info: Displays network mode, IP address of phone, network, and
gateway information.
3.
Netmask
4.
Gateway
Note that items 2 to 4 are only displayed when setting Manual IP.
3. NETWORK SETUP
This menu allows you to individually setup the same parameters found in the
Easy Wizard.
4. LOAD & UPGRADE SETUP
1.
Upgrade TFTP Server:The IP address of the TFTP server containing the ITP
software.
2.
Upgrade Start: Starts the ITP software upgrade process.
5. SYSTEM SERVER SETUP
1.
Server IP Address: The MCP's IP address.
2.
Server ID: The ID assigned to your ITP (see your phone administrator for
this information).
3.
Server Pass: The password assigned to your ITP (see your phone adminis-
tratror for this information).
6. FACTORY RESET
This option resets ITP to factory default settings.
7. REBOOT
This option reboots the ITP.
ITP-5121D
Table of Contents
11