Table of Contents
Advertisement
To access Aux buses on the KM-H2500:
1
2
1
2
1.
Press AUX SEL to display the Aux menu.
2.
Select an Aux bus by pressing the corresponding
knob.
To access Aux buses on the KM-H3000:
1
1.
Select the desired Aux bus by pressing AUX 1 -
3.
Selecting a Source for the Aux Buses
Once an Aux bus has been selected, you can change
the source.
To select a source for an Aux bus:
1.
Select the Aux bus you wish to choose a source
on.
2.
Press the desired source button on the Key/Aux
bus.
Selecting a Special Source for the Aux Buses
You can select the following special sources by
selecting them on the Preset bus:
• Program (AUX PGM)
• Preview (AUX PV)
• Clean Feed (AUX CLN)
• Chroma Key Alpha (fourth source button)
These special sources are found on the first four
buttons on the Preset bus.
To select a special source for an Aux bus:
1
3
2
1.
Select the Aux bus you wish to choose a source
on.
2.
Press and hold SHIFT on the Key/Aux bus.
3.
Press any of AUX PGM, AUX PV, AUX CLN, or
the fourth source button (to access Chroma Key
Alpha) on the Preset bus.
Tallies
The switcher has tally relays assigned to inputs as
follows (pin 1 is the top right pin when looking at the
Tally Port):
5
4
3
2
1
9
8
7
6
Figure 11 Tally Port
Pin
Input
1
1
2
3
3
5
4
7
5
Common Ground
6
2
7
4
8
6
9
8
When the corresponding input is on-air, the
associated tally pin is closed, creating a contact
closure.
Note:
• Tally wiring can be difficult. Consult with your
facility engineer before undertaking any tally
wiring.
For More Information on...
• port locations, refer to the section “Control Panel
Rear Connections Overview” on page 2
Page 34
- Quick Links:
- Input Bnc Configuration
Hide quick links:
Advertisement
Table of Contents
