The digital scanner must perform two charge cycles to complete the battery reconditioning process
3.
(discharge/charge/discharge/charge). See
Battery Reconditioning LED Definitions
Battery Reconditioning LED Definitions
Table 1-2
Battery Reconditioning
Mode
Discharging
Charging
Reconditioning Complete
Inserting the Digital Scanner in the Cradle
Insert the digital scanner in the cradle so that the metal contacts on the bottom of the digital scanner handle touch
the contacts on the cradle. Push the handle lightly to ensure a proper connection, engaging the contacts in the
cradle and digital scanner. Ensure the desk/wall mount converter knob on the back of the cradle is in the correct
position for the horizontal or vertical mounting.
NOTE References to mounting the cradle only apply to the CR0078-S/CR0008-S cradle (not the CR0078-P
cradle).
Table
1-2.
LED
Red Flash
Green Flash
Green - Solid (always on)
Comments
Time to discharge is approximately 2.5 hours.
Time to charge is approximately 2.5 hours with an
external power supply.
The digital scanner enters a trickle charge until the
digital scanner is removed from the cradle.
Getting Started 1 - 13