Control Settings - GE ADW1000 Owner's Manual

Control Settings

Cycles
POTS & PANS/ For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included.
HEAVY WASH This cycle will not remove burned-on foods.
(on some models)
NORMAL/ For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Many dishes have lighter
NORMAL WASH soil than normal. Choosing a cycle other than NORMAL WASH will save energy and water.
SHORT WASH For quickly washing loads of everyday dishes with medium soils that have not dried on, such as loads
consisting mostly of glasses.
(on some models)
WATER SAVER For dishes with light soils.
LIGHT WASH
(on some models)
RINSE ONLY For rinsing partial loads that will be washed later. Do not use detergent.
DRYING For warming clean dishes and serving plates. This cycle will take approximately 30 minutes.
PLATE WARMER
HOT PREWASH Preheats wash water to the correct temperature.
HOT START
CHINA CRYSTAL For lightly soiled china and crystal.
(on some models)
Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
HI TEMP Turns on the heater in all postrinse and final rinse cycles to help prevent spotting on dishware. This
RINSE option may be turned ON or OFF during the wash cycle.
(on some models)
HI TEMP Energizes the heater to boost water temperature in all prewash and main wash fill cycles. Recommended
WASH for use with heavily soiled dishes. Option may be turned ON or OFF during the wash cycle.
HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved.
OFF
HEATED DRY Turns the heater on for fast drying. This cycle will extend the time to your wash cycle by 30 minutes.
ON
NOTE: Cannot be selected with RINSE ONLY cycle.
LOCK When the LOCK pad is touched twice within 3 seconds, all pads become inoperative. You can lock the controls to
prevent any selections from being made. Or you can lock the controls after you have started a cycle or selected
(on some models)
DELAY START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice within 3 seconds. The light above
the LOCK pad will turn off.
DELAY HOURS You can delay the start of a wash cycle for up to 8 hours. Press the DELAY HOURS pad to choose the
number of hours you want to delay the start of the cycle, then press START/RESET. The machine will count
(on some models)
down and start automatically at the correct time. Pressing START/RESET a second time will cancel the
DELAY HOURS selection.
NOTE: If you forget to fully close the door, a reminder signal will beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle. After water is
pumped out and the motor stops, you can reprogram and restart the dishwasher. This will take
(on some models)
approximately 90 seconds.
NOTE: On GSD3900 model, the light above the selected pad will be ON to indicate which OPTION has been selected.
Start (Models with a Dial)
Slowly turn the Dial to the START or ON position, or the selected cycle. Don't turn it past the START, ON
or cycle position, or you could accidentally miss a rinse.
There is a time delay between start-up and water fill so you will not hear any wash action right away.
I
Latch the door to begin the cycle.
ge.com
5