Join Function - JVC 0200JTMMDWJSCEN Instructions Manual

Continued
• If "TRACK PROTECTED" appears, the selected
track has been write-protected by another
component. You cannot edit such a protected track.
To cancel the editing, press TITLE/EDIT button.
5
Press SET button when you find the point where you
want to divide the track.
The MD recorder repeats the selected point — a portion
of three seconds length following the dividing point.
• If you have selected a wrong track number, press
CANCEL button then select the correct track.
6
Rotate MULTI JOG dial ( < / > button also available)
to precisely adjust the dividing point.
• You can shift the dividing point up to ±128. This range
(±128) corresponds to approximately ±8 seconds from
the original point (Position 0).
When you stop rotating MULTI JOG dial, the system
repeats the newly selected dividing point.
7
When you find the right position, press SET button.
"PUSH ENTER" appears in the display window.
8
Press ENTER button to finish the editing procedures.
• If you want to cancel the editing, press CANCEL
button.
9
Press 0 (eject) button to eject the MD.
"WRITING" appears while the editing you have made
is being recorded onto the MD.
To join the divided tracks again, see the JOIN function.
21

JOIN Function

This function allows you to join two adjacent tracks into
one track.
• To quit any time during editing process, press TITLE/
EDIT button.
1
Insert an MD you want to edit into the MD loading
slot.
The MD IN lamp lights orange.
2
Press TITLE/EDIT button until "JOIN?" appears
in the display window.
3
Press SET button.
4
Rotate MULTI JOG dial to select the two adjacent
tracks you want to join (< / > button also available ).
5
Press SET button.
• If you have selected wrong tracks, press CANCEL
button, then select the correct tracks by rotating
MULTI JOG dial (< / > button also available).
• If you want to cancel the editing, press TITLE/EDIT
button.
• If "TRACK PROTECTED" appears, the selected
track has been write-protected by another component.
You cannot edit such a protected track. To cancel the
editing, press TITLE/EDIT button.
6
Press ENTER button to finish the editing
procedures.
7
Press 0 (eject) button to eject the MD.
"WRITING" appears while the editing you have made
is being recorded on the MD.
To divide the joined tracks, see the DIVIDE function.