Table of Contents
Advertisement
O
perations
Power cord
The power cord is located at the rear of the
vacuum. Gently pull out the power cord,
watching for the yellow line. Stop pulling the
power cord once the yellow line is visible.
There is also a red line, which indicates the
end of the usable cord. Do not pull the power
cord out beyond the red line.
Automatic cord rewind
Your vacuum is equipped with an automatic
cord rewind. When cleaning is finished, press
the power button OFF (
to disconnect from the electrical outlet. Hold
the plug and press the automatic cord rewind
button to rewind the cord automatically.
Power button
Turn the power ON or OFF by pressing lightly
downward on the power button ( ).
Variable suction power control
The variable suction power control is located
on the back of the vacuum. Turn the control
toward the larger dots for maximum suction.
Turn the control toward the smaller dots to
minimize suction for lightly soiled areas or
delicate fabrics.
Air flow regulator
Open the air flow regulator by sliding the
regulator back towards the handle to an open
position. This will reduce the suction power
for vacuuming delicate fabrics.
For full suction power, close the air flow
regulator by sliding the regulator forward
to the closed position.
CAUTION:
Before using your vacuum, make
sure that the dirt container
and all filters (pre-motor and
post-motor) are in place. Do
not operate your vacuum without
the dirt container and filters.
w w w . b i s s e l l . c o m
) and grasp the plug
CAUTION:
Be careful to avoid injury as
cord retracts very quickly.
Power
Button
Variable Suction
Control
Air Flow
Regulator
Automatic Cord
Rewind Button
Tip:
Use the variable
suction power
control and the
air flow regulator
to reduce air flow
as needed when
using the tools.
6
Advertisement
Table of Contents
