Setting Up; Attaching The Table-Top Stand - Sony KDL-60NX815 Operating Instructions Manual

Setting Up

Attaching the Table-Top
Stand
Refer to the supplied Table-Top Stand leaflet
for proper attachment for some TV models.
~
• For best picture quality, do not expose the screen
to direct illumination or sunlight.
• If the TV is brought directly from a cold to a warm
location, or is placed in a very damp room, or is
placed in a room in which heating has just been
turned on, moisture may condense on the surface
or inside the TV. Should this occur, turn off the
TV and leave the TV off until the moisture
evaporates, and then the TV can be used. If you
notice moisture condensation between the glass
panel and the LCD, turn on the TV and the
condensation will evaporate after the TV has
warmed up.
For KDL-52/40NX800, KDL-46/40NX700
1
Place the TV set on the Table-Top
Stand.
2
Fix the TV to the Table-Top Stand
according to the arrow marks
guide the screw holes using the
supplied screws.
~
• If using an electric screwdriver, set the tightening
torque at approximately 1.5 N·m {15 kgf·cm}.
3
After all the screws are tightened,
attach the supplied stand rear cover to
the Table-Top Stand.
For KDL-60/55NX815, KDL-60/55NX810,
KDL-46/40NX710
1
Align with the two dowels of the Table-
Top Stand, and gently place the TV,
checking the f mark is facing the front.
2
Attach the TV and Table-Top Stand
with the supplied screw and hexagon
wrench.
that
~
• Set the torque setting to approximately 3 N·m
{30 kgf·cm}.
Reattaching the Table-Top Stand to the
TV
Attach to the original position using the
removed screws. See "Detaching the Table-
Top Stand from the TV" (page 9).
(Continued)
5
GB