Specifications; Double Insulation - Makita LH1200FL Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model
Blade diameter
Blade body thickness
Hole diameter
For all countries other than European countries
For European countries
Max. Cutting capacities (H x W) with blade 305 mm in diameter in the miter saw mode
Bevel angle
90°
45°
Max. Cutting capacities at 90°in the table saw (bench saw mode)
-1
No load speed (min )
Laser Type
Table size (W x L)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･

DOUBLE INSULATION

･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When using the tool in the miter saw mode,
secure the top table at the topmost position
so that the saw blade never protrudes from
the top surface of the top table.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
90°
95 mm x 155 mm
62 mm x 200 mm
64 mm x 155 mm
40 mm x 200 mm
END292-5
Intended use
The tool is intended for accurate straight cutting and
(only when used as a miter saw on the lower table) miter
cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
2
Miter angle
45° (left to right)
95 mm x 110 mm
62 mm x 135 mm
64 mm x 65 mm
40 mm x 85 mm
Red Laser 650 nm,
596 mm x 506 mm x 620 mm
･
Never look into the laser beam. Direct
laser beam may injure your eyes.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance
Directive, on Waste
Electronic Equipment
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
LH1200FL
305 mm
1.9 mm or less
25.4 mm
30 mm
52 mm
3,800
1mW (Laser Class 2)
307 mm x 465 mm
20.7 kg
/II
of the European
Electric and
and its
compatible
ENE060-1
ENF002-2