Operating Other Manufacturers' Video Equipment - JVC TH-A10R Instructions Manual

Operating Other Manufacturers' Video Equipment

This primary remote control can transmit control signals for other
manufacturers' VCRs and TVs. By changing the transmittable
signals from preset ones to the other manufacturers', you can
operate the other manufacturer's components using this remote
control.
When operating the other manufacturers' components, refer also to
the manuals supplied with them. To operate these components with
the remote control, first you need to set the manufacturer's code
each for VCR and TV.
Primary remote control
To change the transmittable signals for operating
another manufacturer's TV ———————————
1.
Press and hold
2.
Press TV/DBS.
3.
Enter manufacturer's code (two digits) using
buttons 1 ~ 9, and 0.
See the list on page 58 to find the code.
Examples: For a JVC product, press 0 then 1.
For a Magnavox product, press 1 then 0.
4.
Release TV.
The following buttons can be used for operating the TV:
TV : Turns on and off the TV.
TV VOL +/– : Adjusts the volume.
TV/VIDEO : Sets the input mode (either TV or VIDEO).
After pressing TV/DBS, you can perform the following
operations on a TV:
CHANNEL +/– : Changes the channels.
1 ~ 10, 0, 100+ (+10) : Selects the channels.
100+ (+10) button will function as the
ENTER button if your TV requires
pressing ENTER after selecting a channel
number.
Note:
• Refer to the manual supplied with your TV.
5.
Try to operate your TV by pressing
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV, try
each one until the correct one is entered.
TV.
TV.
57