Muting The Sound; Selecting The Source To Play; Changing The Source Name - JVC TH-A10R Instructions Manual

Muting the sound

Primary remote control only:
Press MUTING to mute the sound through all speakers
connected.
"MUTING" appears on the display window and volume turns off.
To restore the sound, press MUTING again so that "OFF" appears
on the display.
• Pressing VOLUME +/– also restores the sound.

Selecting the source to play

Selected source name appears
From the remote controls:
Primary remote control
Source selecting buttons
Press one of the source selecting buttons.
DVD*
Select the DVD player.
VCR Select the video component connected to the
VCR jacks.
TV/DBS
Select TV sounds or DBS tuner.
TAPE/MD* Select the cassette deck (or the MD recorder).
AUX*
Select a component connected to the AUX jack.
FM/AM*
Select an FM or AM (MW) broadcast.
Each time you press the button, the band
alternates between FM and AM (MW).
Notes:
• When connecting an MD recorder (to TAPE/MD jacks), and a
DBS tuner (to the TV SOUND/DBS jacks), change the source
name shown on the display window. For details, "Changing the
source name".
• When you press one of the source selecting buttons on the remote
control marked above with an asterisk (*), the system automatically
turns on.
MUTING
Secondary remote control
Source selecting buttons
On the front panel:
SOURCE
Press SOURCE until the source name you want appears
on the display.
The source changes as shown below each time the button is pressed.
= DVD = TAPE (or MD) = VCR = AM = FM =
TV SOUND (or DBS) = AUX = (back to the beginning)

Changing the source name

When you have connected an MD recorder to the TAPE/MD jacks
or the DBS tuner to the TV SOUND/DBS jacks on the rear panel,
change the source name shown on the display window when you
select the MD recorder or DBS tuner as the source.
On the front panel:
1
1.
When changing the source name from "TAPE " to
"MD":
Press SOURCE until "TAPE" appears.
When changing the source name from "TV SOUND"
to "DBS":
Press SOURCE until "TV SOUND" appears.
2.
Press and hold SOURCE NAME until "ASSGN. MD"
or "ASSGN. DBS" appears on the display window.
To change the source name to "TAPE" or "TV SOUND", repeat the
same procedure above — in step 1, select "MD" or "DBS" then
press and hold SOURCE NAME.
Note:
Without changing the source name, you can still use the connected
components, there may be some inconvenience.
• "TAPE" or "TV SOUND" will appear on the display window
when you select the MD recorder or DBS tuner.
• You cannot use the digital input (see page 9) for the MD recorder
and the DBS tuner.
• You cannot use the COMPU LINK remote control system (see
page 54) operate the MD recorder.
Basic operations
2
17