Rear Panel - Korg KF4 Owner's Manual

Rear Panel

1. INPUT 1 S-VIDEO connector
This input accepts an S-VIDEO connector.
2. INPUT 1 jack
This input accepts a composite video signal.
If you connect both the S-VIDEO connector and the INPUT 1 jack, only the S-VIDEO input will
be effective.
3. INPUT 2 jack, INPUT 3 jack
These inputs accept composite video signals.
4. OUTPUT S-VIDEO connector
This output provides the output from the krossfour's mixer as an S-VIDEO signal. Specifically,
this signal will be the signals from Channel A and Channel B (as selected by the INPUT SELECT
keys), after they have been mixed and processed by the fader.
5. OUTPUT jack
This output provides the output from the krossfour's mixer as a composite video signal
Note: The OUTPUT S-VIDEO connector and the OUTPUT jack both provide the same content. Both outputs can
be used at the same time.
6. NTSC/PAL switch
This switch is used to select the video standard you are using. Turn the krossfour off to change
the setting on this switch. The krossfour reads the setting of this switch when power is first
turned on, and the setting cannot be changed until you turn the power off.
NTSC: Japan, North America, etc.
PAL: Europe, etc.
Note: Be sure this switch is set to match the standard of your input signals, or the output signal will be garbled.
7. DC 7V IN
Connect the AC adaptor (included) to this jack.
8. Power switch
Switches the power between ON and STANDBY.
8 7 6 5 4 3 2 1
7