Connect The Cable To The Outdoor Unit - Panasonic CS-E28GKE Service Manual

11.4.4. CONNECT THE CABLE TO THE OUTDOOR UNIT

(FOR DETAIL REFER TO WIRING DIAGRAM AT UNIT)
1. Remove the control board cover from the unit by
loosening the screw.
2. Connecting cable between indoor unit and outdoor unit
shall be approved polychloroprene sheathed 4 x 2.5 mm
flexible cord, type designation 245 IEC 57 or heavier
cord.
3. Secure the cable onto the control board with the holder
(clamper).
4. Cable connection to the power supply through knife
switch (Disconnecting means).
• Connect the approved polychloroprene sheathed power
supply cable (3 x 4.0 mm
or heavier cord to the terminal board, and connect the
other end of the cable to knife switch (Disconnecting
means).
5. Select required direction and apply protective bushing
provided in accessories to protect cables from sharp
edges.
6. Once all wiring work has been completed, tie the wires
and cord together with the binding strap so that they do
not touch other parts such as the compressor and pipes.
Note: Knife switch (Disconnecting means) should have
minimum 3.5 mm contact gap.
• Secure the cable onto the control board with the holder
(clamper).
2
), type designation 245 IEC 57
2
31