Checking Throttle Valve Control Shaft End Play - APRILIA RSV 1000 R FACTORY Workshop Manual

RSV 1000 R - RSV 1000 R FACTORY
3.3.6. CHECKING THROTTLE VALVE CONTROL
SHAFT END PLAY
•
Partially remove the fuel tank.
•
Remove the air filter casing.
NOTE Have an appropriate thickness gauge (1) with a
0.00197 in (0.05 mm) scale at hand.
With throttle valves closed:
•
Use the thickness gauge (1) to measure the minimum
play between the lever (2) and the contact surface (3)
on the throttle body in a number of points.
End play: min. 0.00394 in (0.1 mm).
CAUTION
If the minimum value measured is lower than
0.00394 in (0.1 mm), the throttle body must be
replaced.
With throttle valves open:
•
Repeat the above procedure.
End play: min. 0.0059 in (0.15 mm).
CAUTION
If the minimum value measured is lower than
0.0059 in (0.15 mm), the throttle body must be
replaced.
FUEL SYSTEM
3 - 27