CYCLE PARTS
5.9.2.
CHECKING THE REAR BRAKE DISC
NOTE These operations must be performed with the brake
disc installed on the wheel.
•
Check the wear on the brake disc. Using a micrometer,
measure the minimum thickness in several places. If
the minimum thickness is below the minimum value,
even in a single point, change the disc.
Brake disc min. thickness: 2.95 in (4 mm).
•
Using a comparator, make sure that the disc's maxi-
mum wobbling does not exceed the limit value, other-
wise change it.
Brake disc max. wobbling: 0.22 in (0.3 mm)
5 - 130
RSV 1000 R - RSV 1000 R FACTORY