Advertisement
Quick Links
Advertisement
Summary of Contents for Spylamp2 Bicycle GPS Tracker
- Page 1 Spylamp2 Bicycle GPS Tracker Instruction Manual Version 2.0.0.5...
- Page 2 Getting Started Your GPS tracker is controlled via text message. You will need your mobile phone and a SIM card (2G) with credit on it 1) Charge the tracker with the charging cord provided. Approximately 3 hours should be sufficient but overnight is best. 2) Remove the light cover and insert your SIM card.
- Page 3 7) Send the following texts to set up live tracking setapn www.mynetworkapn.com - Substitute network APN setuser myuser mypassword - Substitute network user and password You will need to find your APN, username and password for your mobile network. These are usually easy to find. Try these pages : The APN section on the support tab of our website http://www.integratedtrackers.com/GPSTrack/Support.jsp www.quickim.com/support/gprs-settings.html...
- Page 4 Testing Obtaining the location of the tracker 1) Go outside and turn the tracker's light on and off. This will cause the tracker to connect to the mobile network so that it is active. 2) Wait 30 seconds for it to connect to the GSM network (during this time you may see the green light come on.
- Page 5 Arming the tracker The tracker contains a vibration sensor. This is useful when you want to lock your bicycle up somewhere and want to be notified if anyone touches it. Hold down the on/off button on the back of the tracker for 5 seconds.
- Page 6 If the tracker is stolen If your bicycle is stolen and the tracker was armed, you will receive an SMS text message to your phone as soon as vibrations are detected (if you have not activated the vibration sensor, you should send the text arm). The tracker will then obtain a GPS lock and begin uploading its location to the online tracking service.
- Page 7 Battery The tracker contains a lithium ion battery. This battery, when fully charged, should be enough to run the tracker for months. It is best to keep it well charged. There are a number of factors which affect battery life, including how much you use the light, the network signal strength and the wakeup interval.
- Page 8 *NB : You must have the correct APN, IP and port configuration set up to download new software versions. Only perform this step when necessary Installation Spylamp2 is designed to function as a tail light, attached to your bicycle seatpost. It is advisable not to use a quick-release seatpost clamp when using spylamp2.
- Page 9 These instructions are valid for the tracker at the time of writing. You can download new versions of software to your tracker from time to time when they are released. Because of this, specific functions may be added or changed. Refer to the Spylamp2 page of the website for the latest instructions...
- Page 10 Warranty GPS TRACKER PURCHASE DATE ____________________________________ If your tracker is faulty within 12 months of purchase then it will be replaced or refunded at your discretion. We do not accept responsibility for any damage that may occur to equipment during the use, misuse or installation of your tracker above the price of the unit.
Need help?
Do you have a question about the Bicycle GPS Tracker and is the answer not in the manual?
Questions and answers