Table of Contents
Advertisement
Step 11. Position the new memory module over the memory connector. Make sure the notch
memory module is correctly aligned with the connector key
memory module straight down into the connector until the retaining clips close.
Step 12. Reattach the computer cover.
Replacing the adapter
Note: For this procedure, it helps to lay the computer flat.
To replace the adapter:
Step 1.
Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Disconnect the power cables from the connectors on motherboard.
Step 3.
Install the new adapter：
a.
Connect the power cables to the connectors on the motherboard.
2
on the system board. Push the
.
Chapter 8
Replacing hardware
1
on the
37
Hide quick links:
Advertisement
Table of Contents
