Download Print this page

Advertisement

286
Effects
Dynamics (Dynamic)
4: St.MasteringLimtr
(Stereo Mastering Limiter)
This is a stereo limiter that is optimized for mastering songs.
Stereo In - Stereo Out
Left
+
Envelope - Control
Right
a
Threshold [dB] –30.0...0.0
Out Ceiling
b
–30.0...0.0
[dB]
c
Release [msec] 0.50...1000.0
Dry, 1:99...99:1,
Wet/Dry
Wet
d
Src
Off...Tempo
Amt
–100...+100
5: Stereo Gate
This effect mutes the input signal when it falls below a specified
level. You can also invert the on/off status of the gate, or use
note-on/off messages to turn the gate on/off directly.
Stereo In - Stereo Out
Left
Envelope Source
Side PEQ
Envelope - Control
+
Envelope - Control
Envelope Select
D
-mod
Right
FX Control BUS 1
FX Control BUS 2
Envelope
a
D-mod, Input
Source
L/R Mix,
Envelope
L Only,
Select
R Only
b
Src
Off...Tempo
Threshold
0...100
c
Polarity
+, –
Attack
1...100
d
Release
1...100
Delay Time
e
0...100
[msec]
Side PEQ Insert Off, On
f
Trigger
Off, On
Monitor
Side PEQ
20...12.00k
Cutoff [Hz]
g
Q
0.5...10.0
Gain [dB]
–18.0...+18.0
Dry, 1:99...99:1,
Wet/Dry
Wet
h
Src
Off...Tempo
Amt
–100...+100
FX Amt
Out Ceiling
Limiter
Limiter
Out Ceiling
FX Amt
Sets the level above which the
compressor is applied
Sets the output gain
Sets the release time
Balance between the wet and dry
signal
Table , "Dynamic Modulation
sources, " on page 283
Amount of modulation source
FX Amt
Gain Adjust
Delay
Gate
Trigger Monitor
Delay
Gate
Gain Adjust
FX Amt
Selects the source to control the
gate: D-mod control, or use the
input signal as a trigger
Selects the control signal: left and
right linked, left only, or right only
Selects the source that will control
the gate when Envelope Src = D-
mod
Sets the level at which gating is
applied
Switches the polarity of gating
Sets the attack time
Sets the release time
Sets the delay time for the gate
input
Switches the trigger signal equalizer
on/off
Switches between monitoring the
effect output and the trigger signal
Sets the center frequency of the
equalizer for the trigger signal
Sets the bandwidth of the equalizer
for the trigger signal
Sets the gain of the equalizer for the
trigger signal
Balance between the wet and dry
signal
Table , "Dynamic Modulation
sources, " on page 283
Amount of modulation source
c: Threshold
d: Attack
d: Release
"Threshold" specifies the level at which gating occurs when
"Envelope Select" is set to L/R Mix, L Only, or R Only.
"Attack" and "Release" specify the attack time and release time of
the gate.
Output Level
Threshold
Dry
Wet
Wet
Attack
c: Polarity
This inverts the polarity of the gate on/off operation. With the
"–" setting, the gate will close when the input signal exceeds the
specified level. The direction in which the modulation source
opens or closes the gate will also be reversed.
e: Delay Time [msec]
This sets the delay time for the input to the gate. When using
shorter Attack Time settings, you can lengthen the Delay Time
so that the sound is input after the gate opens.
Gate - Threshold
Louder
Input Level
Gate - Attack / Release
Threshold
Attack=1
Release=1
Attack=100
Release=100
Release

Advertisement

   Also See for Korg Pa300

Comments to this Manuals

Symbols: 0
Latest comments: