Electrical Connection - Miele G 7881 Operating Instructions Manual

,
All electrical work must be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations (BS 7671
in the UK).
– Connection should be made via a
suitable isolator, with an on-off switch
which is easily accessible for
servicing and maintenance work
after the machine has been installed.
An electrical safety test must be
carried out after installation and after
any servicing work. When switched
off there must be an all-pole contact
gap of at least 3 mm in the mains
connection switch.
– The mains connection cable may
only be replaced by an original Miele
spare part or an appropriate cable
with wire end ferrules.
– For technical data see data plate or
wiring diagram supplied.

Electrical connection

The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate.
This machine can be converted in
accordance with the conversion
diagram and wiring diagram supplied.
The data plate with test certification is
on the rear of the machine and also
behind the plinth panel on the
protective plastic cover.
The wiring diagram is supplied with
the machine.
See also the installation diagram
supplied.
Bonding connection
There is a screw connection point
marked with the earth symbol (
the back of the machine, to which the
earth lead must be connected.
WARNING
THIS APPLIANCE
MUST BE EARTHED
8
) at
63