7.5 Cavitron JET Air Polishing Inserts
Air Polishing Insert Nozzle:
Tube-in-a-tube design delivers
mixture at point
Manufacturer, Date (YDDD=Single Digit
Year and Triple Digit Day of the Year).
7.6 Wireless Foot Control Operation
The foot control is a two-positioned momentary switch.
For scaling operation, the first position activates both the
ultrasonic energy and lavage at the insert tip. The second
position activates the Boost Mode. The Boost Mode (fully
depressed Foot Control) increases the ultrasonic power level
for quick, efficient removal of tenacious deposits without
adjusting the power level knob. To deactivate Boost Mode,
release foot control to first position.
For prophy operation, the first position activates Rinse
Mode. The second position activates Air Polishing Mode.
(Boost Indicator will not illuminate.)
Pressing anywhere on the top of the foot control
activates the system.
7.7 Accessories and User
AC Power Cord
Dual Position Foot Control (Wireless)
Auxiliary Foot Control Power Cable
Cavitron JET-Mate Sterilizable Handpiece
Prophy Handpiece Cleaning Wire
Cavitron 30K Ultrasonic Inserts
Cavitron DualSelect Dispensing system
Cavitron JET Air Polishing Insert
Cavitron JET Nozzle Cleaning Tool
10. JetShield Aerosol Reduction Device
Prophy Powder Delivery Tube:
Directs air/powder flow to insert tip.
Seals water when Insert is fully seated in Handpiece.
O-ring should be replaced when worn.
User Replaceable Part Kits
Powder Bowl Cap O-Ring, Part Number 628052001
Powder Bowl Cap, Part Number 81728
Cavitron Insert Replacement O-ring Kits, 12/packs
Part Number 62351 (black) for plastic and soft grips
Part Number 62605 (green) for metal grips and prophy
Handpiece Cable O-Ring , Part Number 79357
JET-Mate Handpiece Nozzle Grip, 81717
Lavage (Water) Filter, 10/Pack, Part Number 90158
For detailed information, contact your local DENTSPLY
Professional Representative or authorized DENTSPLY
SECTION 8: System Setup,
Operation and Techniques
8.1 Handpiece Setup
Connect the Handpiece to the Cable Assembly by
aligning the electrical connections. If Cable Assembly
does not seat into the handpiece, gently rotate the
handpiece until contacts align, then fully insert handpiece.
Hold empty handpiece in a semi-upright position over a
sink or drain. Activate the Foot Control until water exits
to bleed any air bubbles that might be trapped inside the
handpiece. Avoid letting water into the Powder Delivery
Port as clogging may result.
Insert Heater Rod:
Heats the delivered water for