Electrolux EI15IM55GS Service Manual page 32

32
Service Information
Disposal Assembly
Spigot Assembly
Before installing your U-Line CLR2160 with factory-
pump, EIMP60
installed U-Line P60 pump, it is extremely important
to check and test all hose connections at the drain
pump. There is a possibility that hose connections
may have loosened during shipment.
To prevent accidental electrocution, make certain
that the floor surfaces surrounding the unit are
dry whenever power is removed from, or applied
to, the unit.
To check and test hose connections:
1. Make certain the unit is not plugged into an electrical
outlet.
2. Carefully push the power cord grommet through the
hole in the back panel (Figure 7).
Air Gap
(Optional Hook-Up)
Hot
Water
ULIN_0572_A
Figure 5
Air Gap
(Optional Hook-Up)
Shut-Off
Valve
Hot
Water
ULIN_0573_A
Figure 6
IMPORTANT IMPORTANT
E151M
WARNING
Screws
Waste
Cold
Water
Shut-Off
Valve
Power
Cord
3. Remove 12 screws and back panel.
Back panel serves as a guard. DO NOT put your
hands inside the ice maker cabinet or attempt to
touch any components except the discharge tube
during testing. Failure to follow this warning
Waste
could result in serious personal injury or death.
4. Check that the clamps and hose connections are tight at
the following areas (Figure 8):
Cold
Water
• Discharge tube (A)
• Drain tube (B)
• Vent tube (C)
B
Back View
5. Place a suitable container beneath the pump's discharge
tube. (The bucket must be able to hold a minimum of
one gallon.)
6. Plug the ice maker power cord into a properly
grounded, polarized electrical outlet.
7. Verify pump operation by pouring one gallon of water
into the ice storage bin of the ice maker. The pump
should energize and pump the water into the container.
8. At this time, verify that all tube and clamp connections
are tight and leak free.
Model CLR2160
Grommet
Water
Drain
Connection
Fitting
ULIN_0574_A
Figure 7
WARNING
C C
A
Side View
ULIN_0575_A
Figure 8
Back
Panel
B
41