Download  Print this page
   

Advertisement

2-42 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Remove the rear caliper (see Caliper Removal in the
Brakes chapter).
Remove the pads (see Brake Pad Removal in the Brakes
chapter).
Separate the caliper holder [B] from the caliper [A].
Using compressed air, remove the piston.
Cover the caliper opening with a clean, heavy cloth [A].
Remove the piston by lightly applying compressed air [B]
to where the brake line fits into the caliper.
To avoid serious injury, never place your fingers or
palm inside the caliper opening. If you apply com-
pressed air into the caliper in such condition, the
piston may crush your hand or finger.
Pull out the piston [A] by hand.
Remove the dust seal [B] and fluid seal [C].
Clean the caliper parts except for the pads.
For cleaning of the parts, use only disc brake fluid,
isopropyl alcohol, or ethyl alcohol.
The bleed valve was removed, install the bleed valve and
rubber cap.
Torque - Bleed Valve: 7.8 N·m (0.80 kgf·m, 69 in·lb)
Replace the fluid seal(s) [A] with new ones.
Apply brake fluid to the fluid seal(s), and install them into
the cylinders by hand.
Replace the dust seal(s) [B] with new ones.
Apply brake fluid to the dust seal(s), and install them into
the cylinder by hand.
Apply brake fluid to the outside of the pistons [C], and
push them into each cylinder by hand.
WARNING
CAUTION

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f