Ignition Timing Inspection
Remove the timing inspection plug [A].
Special Tool - Filler Cap Driver: 57001-1454
Attach the timing light [A] to the ignition coil lead in the
manner prescribed by the manufacturer.
Special Tool - Timing Light: 57001-1241
Start the engine and aim the timing light at the ignition
timing mark [B] on the flywheel.
Run the engine at the speeds specified and note the align-
ment of the ignition timing marks.
Check the engine speed, using the engine revolution
tester [A] for high accuracy.
Engine speed [r/min (rpm)]
If the ignition timing is incorrect, check the crankshaft sen-
sor (see Crankshaft Sensor Inspection).
If the crankshaft sensor are normal, check the C.D.I. unit
(see C.D.I. Unit Inspection).
Install the timing inspection plug.
Hole groove aligns with:
Line mark on flywheel
ELECTRICAL SYSTEM 16-13