Download  Print this page

Flywheel Magneto; Magneto Cover Removal; Magneto Cover Installation; Flywheel Removal - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

Flywheel Magneto

Magneto Cover Removal

Remove the left radiator shroud.
Drain the engine oil from the crank room oil sump (see
Engine Oil Change in the Periodic Maintenance chapter).
Pull the stopper [A] to this side to remove the magneto
lead connector [B].
Disconnect the magneto lead connector from the main
harness.
Remove the shift pedal (see External Shift Mechanism
Removal in the Engine Right Side chapter).
Open the clamp [A] then free the breather hose [B].
Remove:
Magneto Cover Mounting Bolts [C].
Magneto Cover [D]

Magneto Cover Installation

Replace the gasket with a new one.
Be sure to install the dowel pins [A].
Apply silicone sealant to the area [A] to the magneto lead
grommet.
Sealant - Kawasaki Bond (Silicone Sealant): 92104-0004
Put in the magneto lead to the lead holder [A].
Tighten:
Torque - Magneto Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Run the breather hose [B] and magneto lead according
the Cable, Wire, and Hose Routing section in the Appen-
dix chapter.
Connect the lead connector.

Flywheel Removal

Remove the magneto cover (see Magneto Cover Re-
moval).
ELECTRICAL SYSTEM 16-9

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f