Download  Print this page
   

Advertisement

14-10 STEERING
Handlebar
Apply grease to the throttle cable upper end and clutch
cable upper end.
Apply a 2-stroke oil to the throttle grip inner wall [A].
Install the throttle grip assy so that the grip [A] is in as far
as it will go.
Position the throttle grip assy so that the parting line [B]
of the throttle case vertically, and tighten the screws.
Install the front master cylinder (see Front Master Cylinder
Installation in the Brakes chapter).
Install the handlebar [B] on the handlebar holder (lower)
so that the protruded scales of the both side adjust to the
same width [A].
Apply 2-stroke oil to the thread of the handlebar holder
bolts.
Install the handlebar holder (upper) so that center [D] of
the handlebar holder (upper) [C] and handlebar bridge [E]
align.
Torque - Handlebar Holder Bolts: 25 N·m (2.5 kgf·m, 18
ft·lb)
Front [F]
After tighten, make sure the gap [A] [B] of the front and
rear are same width.

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f