Front Fork Lower Clamp Bolts [A]
Front Fork [B]
Pushing up on the stem base [A], and remove the steering
stem nut [B], with the steering stem nut wrench [C], then
remove the steering stem [D] and stem base.
Special Tool - Steering Stem Nut Wrench: 57001-1100
Take off the upper stem bearing inner race (tapered roller
Drive out the bearing outer races from the head pipe.
Remove the outer races pressed into the head pipe, using
the head pipe outer race remover [A], and hammer the
head pipe outer race remover to drive it out.
Special Tool - Head Pipe Outer Race Remover ID > 37 mm:
If either steering stem bearing is damaged, it is recom-
mended that both the upper and lower bearing (includ-
ing outer races) should be replaced with new ones.
Remove the lower stem bearing inner rase (tapered roller
bearing) [A] with its grease seal from the stem using bear-
Special Tools - Bearing Puller: 57001-1575
Bearing Puller: 57001-135