Download  Print this page

Tie-rod And Rocker Arm Bearing Installation; Needle Bearing Inspection - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

Tie-Rod, Rocker Arm

Tie-Rod and Rocker Arm Bearing Installation

Replace the needle bearing, grease seals and oil seals
with new ones.
Apply plenty of grease to the oil seal and needle bearings
[A].
Install the grease seals so that the deep groove side of
the rip out-ward.
Install the needle bearings [A], [B] and grease seals [C]
position as shown.
The installation procedure is the same as the counter
side.
1 mm (0.04 in.) [D]
4.5 mm (0.18 in.) [E]
4.25 mm (0.167 in.) [F] Rocker Arm [I]

Needle Bearing Inspection

If there is any doubt as to the condition of either needle
bearing, replace the bearing and sleeve as a set.
NOTE
Rear Shock Absorber [G]
Tie-rod [H]
SUSPENSION 13-51

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f