Download  Print this page

Rocker Arm Installation; Tie-rod And Rocker Arm Bearing Removal - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

13-50 SUSPENSION
Tie-Rod, Rocker Arm

Rocker Arm Installation

Apply plenty of grease to the inside of the rocker arm,
needle bearings, oil seals and grease seals outside of the
sleeve.
Tighten:
Torque - Rear Shock Absorber Mounting Nut (Lower): 34
N·m (3.5 kgf·m, 25 ft·lb)
Rocker Arm Pivot Nut: 83 N·m (8.5 kgf·m, 61 ft·lb)
(KX450D6F)
Rocker Arm Pivot Nut: 59 N·m (6.0 kgf·m, 43 ft·lb)
(KX450D7F ∼)
Tie-Rod Mounting Nuts: 83 N·m (8.5 kgf·m, 61
ft·lb) (KX450D6F)
Tie-Rod Mounting Nuts: 59 N·m (6.0 kgf·m, 43
ft·lb) (KX450D7F ∼)

Tie-Rod and Rocker Arm Bearing Removal

Remove:
Tie-Rod (see Tie-Rod Removal)
Rocker Arm (see Rocker Arm Removal)
Collars [A]
Sleeves [B]
Oil Seals [C]
Grease Seals [D]
Remove the needle bearings [E], using the bearing re-
mover head and bearing remover shaft.
Remove the needle bearing [F], using the oil seal & bear-
ing remover.
Special Tools - Bearing Remover Head: 57001-1267
Bearing Remover Shaft: 57001-1265
Oil Seal & Bearing Remover: 57001-1058

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f