Download  Print this page

Hub Bearings; Hub Bearing Removal; Hub Bearing Installation; Hub Bearing Inspection - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

10-14 WHEELS/TIRES

Hub Bearings

Hub Bearing Removal

Remove the wheel (see Wheel Removal).
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.
Remove the oil seals and circlips.
Special Tool - Inside Circlip Pliers: 57001-143
Remove the hub bearing by tapping evenly around the
bearing inner race as shown.
[A] Bar
[B] Distance Collar
[C] Hub Bearing

Hub Bearing Installation

Before installing the wheel bearings, blow any dirt or for-
eign particles out of the hub [A] with compressed air to
prevent contamination of the bearings.
Replace the bearings with new ones.
Lubricate them and install them using the bearing driver
set [B] so that the marked or shielded sides face out.
Press in the bearings until they are bottomed.
Special Tool - Bearing Driver Set: 57001-1129
Replace the circlips and oil seals with new ones.
Press in the oil seals [A] so that the seal surface is flush
[B] with the end of the hole.
Apply high temperature grease to the oil seal lips.
Special Tool - Bearing Driver set: 57001-1129 [C]

Hub Bearing Inspection

It is not necessary to remove any bearings for inspec-
tion. If any bearings are removed, they will need to be
replaced with new ones.
Spin [A] it by hand to check its condition.
If it is noisy, does not spin smoothly, or has any rough
spots, it must be replaced.
Examine the bearing seal [B] for tears or leakage.
If the seal is torn or is leaking, replace the bearing.
CAUTION
NOTE

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f