Visually inspect the front and rear axle for damages.
If the axle is damaged or bent, replace it.
Place the axle in V blocks that are 100 mm (3.937 in.) [A]
apart, and set a dial gauge on the axle at a point halfway
between the blocks. Turn the axle to measure the runout.
The difference between the highest and lowest dial read-
ings is the amount of runout.
If the runout exceeds the service limit, replace the axle.
Axle Runout/100 mm (3.94 in.)
TIR 0.1 mm (0.004 in.) or less
Service Limit: TIR 0.2 mm (0.008 in.)