Download  Print this page
   

Advertisement

Wheels (Rims)
Insert the axle [A] from right side.
Tighten the right [B] axle clamp bolts temporally.
Tighten the axle nuts [C].
Tighten the left axle clamp bolts [D].
Torque - Front Axle: 78 N·m (8.0 kgf·m, 58 ft·lb)
Left Axle Clamp Bolts: 20 N·m (2.0 kgf·m, 15 ft·lb)
Tighten the two clamp bolts alternately two times to en-
sure even tightening torque.
Remove the jack.
Before tightening the right clamp bolts on the right fork
leg, pump the forks up and down [A] 4 or 5 times to allow
the right fork leg to find a neutral position on the front axle.
Do not apply the front brake during this process to stop
the motorcycle from rolling forward. Put a block [B] in
front of the wheel to stop it from moving.
Tighten the right axle clamp bolts.
Torque - Right Axle Clamp Bolts: 20 N·m (2.0 kgf·m, 15 ft·lb)
Tighten the two clamp bolts alternately two times to en-
sure even tightening torque.
Check the front brake for good braking power and no
brake drag.
Do not attempt to drive the motorcycle until a full
brake lever is obtained by pumping the brake lever
until the pads are against the disc. The brake will
not function on the first application of the lever if
this is not done.

Rear Wheel Removal

Using the jack under the frame so that the rear wheel is
raised off the ground.
Special Tool - Jack: 57001-1238
Remove the clip [A] from the master link using pliers, and
free the drive chain [B] from the rear sprocket.
NOTE
NOTE
NOTE
WARNING
WHEELS/TIRES 10-7

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f