Download  Print this page

Bearings/oil Seals; Bearing Replacement; Bearing Inspection - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

9-24 CRANKSHAFT/TRANSMISSION

Bearings/Oil Seals

Bearing Replacement

Do not remove the ball bearings unless it is neces-
sary. Removal may damaged them.
Remove the ball bearing and/or needle bearing outer race
using a press or puller.
In the absence of the above mentioned tools, satisfac-
tory results may be obtained by heating the case to ap-
proximately 93°C (200°F) max, and tapping the bearing
in or out.
Do not heat the case with a torch. This will warp the
case. Soak the case in oil and heat the oil.
Install the new bearing until its outer race stops at the
bottom of the case using a press and the bearing driver
set [A].
Special Tool - Bearing Driver Set: 57001-1129

Bearing Inspection

Do not remove the bearings for inspection. Re-
moval may damage them.
Inspect the ball bearings.
Since the ball bearings are made to extremely close toler-
ances, the wear must be judged by feel rather than mea-
surement. Clean each bearing in a high-flash point sol-
vent, dry it (do not spin the bearing while it is dry), and oil
it with engine oil to it.
Spin [A] the bearing by hand to check its condition.
If the bearing is noisy, does not spin smoothly, or has any
rough spots, replace it.
CAUTION
NOTE
CAUTION
CAUTION

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f