Download  Print this page

Transmission Shaft Assembly - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

Table of Contents
Transmission

Transmission Shaft Assembly

Apply engine oil liberally to the transmission shaft, gears
and bearings.
Replace any circlips that were removed with new ones.
Always install the circlips [A] so that the opening [B] is
aligned with a spline groove [C], and install toothed wash-
ers. To install a circlip without damage, first fit the circlip
onto the shaft expanding it just enough to install it, and
then use a suitable gear to push the circlip into place.
Special Tool - Outside Circlip Pliers: 57001-144
The drive shaft gears can be identified by size; the small-
est diameter gear is 1st gear, and the largest is 4th. Be
sure that all parts are put back in the correct sequence,
facing the proper direction, and that all circlips and the
washers are properly in place.
The output shaft gears can be identified by size; the
largest diameter gear is 1st gear, and the smallest is
5th. Be sure that all parts are put back in the correct
sequence, facing the proper direction, and that all circlips
and washers are properly in place.
CRANKSHAFT/TRANSMISSION 9-19

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f