Shift Drum [A] (see Transmission Installation)
Shift Rods [B] (see Transmission Installation)
Shift Forks [C] (see Transmission Installation)
Dowel Pins [B]
Replace the O-ring [A] with a new one.
Install the Oil Screen (Feed).
Torque - Oil Screen (Feed) Mounting Bolts: 9.8 N·m (1.0
kgf·m, 87 in·lb)
With the connecting rod positioned at the bottom-dead
-center, install the crankshaft jig [A].
Special Tool - Crankshaft Jig: 57001-1174
Apply liquid gasket to the mating surface [A] of the left
Sealant - Kawasaki Bond (Liquid Gasket - Gray): 92104
Make the application finish within 30 minutes when the
liquid gasket to the mating surface of the left crankcase
half is applied.
Moreover fit the case and tighten the case bolts just
after finishing the application of the liquid gasket.