Download  Print this page
   

Advertisement

9-10 CRANKSHAFT/TRANSMISSION
Crankcase
Next, press the outside release shaft needle bearing [A]
until the surface of the bearing is even with the crankcase
surface [B].
Special Tool - Bearing driver Set: 57001-1129
Replace the oil seals, if removed.
Press the output shaft and release shaft oil seals [C] so
that oil seal lip [A] face to the engine outside and oil seal
surface flush with the left crankcase surface [B].
Press the shift shaft oil seal until it bottom out so that oil
seal lip face the engine outside.
Apply high-temperature grease to the oil seal lip.
Install the new circlip [D] to the output shaft and release
shaft oil seal.
Special Tool - Bearing driver Set: 57001-1129
Apply a non-permanent locking agent to the bearing re-
taining screw.
Tighten the bearing retaining screws [A].
Torque - Bearing Retaining Screws: 15 N·m (1.5 kgf·m, 11
ft·lb)
Piston Oil Nozzle [B]: 2.9 N·m (0.30 kgf·m, 26 in·lb)
Apply engine oil to the transmission gears, bearings, shift
forks, shift drum and crankshaft bearing.
Install the drive shaft [A] and output shaft [B] in the right
crankcase half [C] as a set.

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f