Download  Print this page

Oil Seal Installation - Kawasaki KX450F Service Manual

Kx450f.
Hide thumbs
   

Advertisement

Water Pump
Insert a bar [A] into the water pump shaft hole from the
outside of the right engine cover, and remove the ball
bearing [B] by tapping [C] evenly around the bearing in-
ner race.
Remove the spacer [D].
Remove the ball bearing [E] and oil seal [F] from the right
engine cover in the same way as ball bearing removal.
Insert a bar [A] into the water pump shaft hole from the
inside of the right engine cover, and remove the oil seal
[B] by tapping [C] evenly around the seal lips.

Oil Seal Installation

If the oil seal or ball bearing is removed, replace all
of them with new ones at the same time
Be sure to replace the oil seals.
Apply plenty of high temperature grease to the oil seal
lips.
Press in the new oil seal [A] using a bearing driver set
from the outside of the right engine cover so that the seal
bottom surface is flush with the end face [B] of the right
engine cover.
Press in the new oil seal [C] using a bearing driver set
from the outside of the right engine cover so that the oil
seal surface is flush [D] with the surface of the right engine
cover.
Special Tool - Bearing Driver Set: 57001-1129
Press the ball bearing [A] together with the spacer [B] into
the hole until the face of the bearing is even [C] with the
end of the hole.
Special Tool - Bearing Driver Set: 57001-1129
CAUTION
COOLING SYSTEM 4-11

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f