Download  Print this page
   

Advertisement

Carburetor
Assembly:
Throttle Valve [A]
Jet Needle [B]
Circlip [C]
Retainer [D]
Spring [E]
Jet Needle Holder [F]
O-ring [G]
Throttle Valve Plate [H]
Assemble the valve plate so that the hole side downward
[I].
Apply a non-permanent locking agent to the link screw.
Insert the throttle valve assembly.
Insert the link rollers [A] on the throttle link into the slits
[B] of the throttle valve.
Tighten the screw.
Apply a grease to the O-ring [A].
Fit the stopper [B] of the throttle sensor onto the projection
[C] on the throttle cable pulley shaft.
Install the throttle sensor so that the marks aligns and
check it position (see Throttle Sensor Inspection in the
Electrical System chapter).
Install:
O-ring [A]
Carburetor Cap [B]
Bolts (tighten)
Install:
Starter Jet [A]
Pilot Jet [B]
Baffle Plate [C]
Needle Jet [D]
Main Jet [E]
FUEL SYSTEM 3-25

Advertisement

Table of Contents

   Also See for Kawasaki KX450F

This manual is also suitable for:

Kx450f 2006Kxf 450

Comments to this Manuals

Symbols: 0
Latest comments:
  • paulo sergio borges Apr 13, 2016 05:03:
    quantidade oleo suspencao kx 450 f