3-10 FUEL SYSTEM
Throttle Grip and Cable
Hot Starter Cable Removal
Dust Cover [A] (Slide out)
Locknut [B] (Loosen)
Turn in the adjuster [C] fully.
Remove the cable end [D] from the hot starter lever [E].
Carburetor (see Carburetor Removal)
Unscrew the plunger cap bolt [A] and remove the cable
Disassemble the cable end from the plunger [A].
Plunger Cap Assy [C]
Left Radiator Shroud
Clamps [A] (Open)
Hot Starter Cable [B]
Hot Starter Cable Installation
Install the hot starter cable in accordance with the Cable,
Wire and Hose Routing section in the appendix chapter.
After the installation, adjust the cable properly.
Operation with an incorrectly routed or improperly
adjusted cable could result in an unsafe riding con-
Hot Starter Lever (Hot Starter Cable) Free Play
Refer to the Hot Starter Lever (Hot Starter Cable) Free
Play Inspection in the Periodic Maintenance chapter.