Defogging Windshield - Hyundai Getz Quick Reference Manual

HOW TO REMOVE WINDSHIELD/WINDOW FOGGING
6
1. Temperature Control
This is used to turn the heating system
on and off and to select the degree of
heating desired.
2. AC "ON/OFF" Switch
The air conditioning is turned on by
pushing the AC button.

DEFOGGING WINDSHIELD

a) To remove internal fog on windshield
• Set air intake to fresh air mode
• Set air flow to defrost
• Turn "ON" the A/C.
• Set temperature control to desired
position.
• Set fan speed as required.
b) To remove external fog on windshield
• Set intake air to fresh air mode
• Set air flow control to defrost
Note:
• Blower without AC should only be used with Fresh Air mode to avoid any fogging.
• Operate AC at first blower speed after initial cooling at high speed.
• Do not turn the air louvers towards window side to prevent formation of fog on
windows.
DOES YOUR A/C GET COLD ENOUGH?
• If the interior of the car is hot when you
first get in, open the window for a few
minutes to expel the hot air.
• When you are using the air conditioning
system, keep all windows closed to keep
hot air out.
1
Getz.indd 1
3. Air Intake Control
This allows you to select fresh outside air
or to recirculate inside air.
4. Air Flow Control
This is used to direct the flow of air.
Air can be directed to the floor, dashboard
outlets or windshield.
5. Fan Speed Control
This is used to turn the blower fan on and
off and to select the fan speed.
6. Rear Window Defroster Switch*
* if equipped
• Set temperature control to warm.
• Set fan speed to higher position.
c) Use Rear Defogger Switch to clear
Rear Windshield fog (If installed)
• The rear windshield defroster is turned
ON by pushing the switch.
• After switching ON, defogger turns OFF
automatically within 20 minutes
• Use same switch to switch 'ON' and
'OFF'
• When moving slowly, as in heavy traffic,
shift to a lower gear. This increases
engine speed, which in turn increases the
speed of the air conditioning compressor.
• On steep grades, turn the air conditioning
off to avoid the possibility of the engine
overheating.
4/10/08 8:21:53 PM