Tuner Setup; Auto Tuner Setup - JVC LCT2224-001C-A User Manual

Tuner Setup

Auto Tuner Setup

The auto tuner setup function is described on page 23 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
To "Tuner Setup"
π †
è
To enter
To "Auto Tuner Setup"
π †
è
To enter
è
To choose "Cable" or "Air"
To "Scan Mode"
π †
è
To choose "Auto", "STD", "HRC" or "IRC"
To "Start"
†
Press the O
The auto tuner is finished when the message "Programming Over !" appears onscreen.
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
• You can also access the "Front Menu" screen by using the M
TV instead of the remote control. It has "Video Status", "Aspect", "Auto Tuner Setup" and
"Menu". Choose "Auto Tuner Setup" by pressing M
using the C
HANNEL
40
button
ENU
button (Programming will take serveral minutes)
K
√
+/- buttons ( OPERATE
Tuner Setup > Auto Tuner Setup
–
+
Tuner Mode
Scan Mode
Select
button on the side of the
ENU
† on the side panel and enter by
ENU
®
).
Air
Auto
Start
BACK MENU
Operate Back Exit